| Item No | name | Specification | Picture/Size | number per pkg |
| 4315-1006-0030 | 4315 Series Steel, MOD 1.25 Miter Gear (6mm D-Bore, 30 Tooth) | These bevel gears are considered miter gears because they create a 1:1 ratio between the drive gear and driven gear. Feel free to mix and match between any two 4315 Series Miter Gears as they are all compatible with one-another.This 6mm D-Bore Miter Gear is able to mate with any other 4315 Series Miter Gear. A miter gear is a specific type of bevel gear. Two mating miter gears create a 1:1 ratio, and transmit power at a 90 degree angle due to the 45 degree pitch cone angle. The underneath side of this gear has been dished out to allow a thrust bearing to set the location of the gear (relative to the inside wall of an 3120 Series U-Channel) and counteract the potential spreading forces in the most extreme applications. Additionally, the 32mm shelf on the back will allow a 32mm diameter component, such as goRAIL, goTUBE or a Sonic Hub to nest down in the cavity and fasten with M4 socket head screws. Weight 24g Material Steel Finish Zinc-Plated Tooth Count 30 Gear Pitch MOD 1.5 Pressure Angle 20 Degree Quantity: pkg of 1 | 1 | |
| 4317-4008-0024 | 4317 Series Steel, MOD 0.8 Miter Gear (8mm REX Bore, 24 Tooth) | Miter gears are a specific type of a bevel gear that create a 1:1 ratio at 90° due to their 45° pitch cone angle. Though we also offer the larger 4315 Series Miter Gears, 4317 Series Miter Gears are sized for more intricate applications that benefit from compactness and lesser rotating mass! This 8mm REX Bore Miter Gear is able to mesh with any other 4317 Series Miter Gear, regardless of bore size. Simply space the back of each miter gear 20mm from the center of the shaft driving the other miter gear, and make sure their shafts are at 90° to each other. This miter gear's 8mm REX bore (as seen in our 7203 Series Yellow Jacket Planetary Gear Motors) is the go-to for beefy, positive drive. Meanwhile, its two M5 set-screws-located on flats 120° apart-ensure that the gear will not move axially along a shaft, even in the most strenuous applications SPECS Weight 16g Material Steel Finish Black Zinc-Plated Pressure Angle 20° | 1 |
