Product Details
Product Description
Product Description
Features:
This equipment can be set to automatic/semi-automatic/manual operation, adopts imported motor imported components, automatic limit, small size, accurate and safe, high reliability and long service life!
Four rotating work surfaces make it more suitable for mass production, and it is the best choice for your assembly line operations.
Digital display, intelligent temperature control, high precision plus or minus 2 degrees;
Digital time display control, high accuracy;
Elegant and beautiful structure
Operation process
Note: The whole machine must have a suitable and reliable protective ground wire.
1. Turn on the power switch and adjust the temperature, time and air pressure to the required requirements.
2. When the temperature is reached, switch the switch to the "manual" position, and try to iron the desired product. After the quality is approved, it can be switched to the "automatic" position for mass production.
3. When the switch is in the "manual" position, manually press the "manual start" heating plate to press down and automatically rise when the time is up. If the position is found to be wrong during the hot stamping process, press "emergency stop" to stop the hot stamping. When the switch is in the "auto" position, just push the heating plate in place and the heating plate will automatically press down.
repair:
1. Air pressure: If the pressure is not enough or too large, adjust the pressure regulating valve on the gas cylinder, increase the pressure in the (+) direction, and reduce the pressure in the (1) direction (please pay attention to whether there is lubricating oil in the gas cylinder).
2. Temperature: When the heating plate does not heat up or the heat is uneven after the device is set to a temperature, the circuit thermostat and thermocouple should be checked. If the thermocouple is broken, there is a disconnection indicator on the thermostat, and the thermocouple should be replaced. .
3. Time: when the switch is set to "manual", press "manual start" and it will not press down, then check the "manual" switch, when the switch is set to "automatic", the table will not be pressed down when it is in place, and the inside of the box should be checked. Whether the contact point of the micro switch is in place, if not, it should be adjusted.
4. If there is any quality problem, please contact our company in time.
technical parameter
Voltage: 220V/110V/380V
Temperature: 0-399 degrees
Power: 2000W
Time: 0-99 minutes
Workbench size: (38*38CM) (40*40CM) (40*50CM) (40*60CM)
Weight: (depending on size)
This machine can heat transfer the color patterns and characters of sublimation and solvent inks on cotton, linen, chemical woven fabrics, etc., and can also perform heat treatment such as flocking heat transfer and foam printing, which is convenient and practical.
>>
Wholesale Multifunctional Garbage Bag Plastic Jumbo Bag
>>
6- 60HP Electronic Fuel Injection outboard motor compatible for Yamaha outboards (China best & largest outboards maket since 2005)
>>
ASTM AISI 201 202 304 304L 316 316L 316ti 430 Duplex 2b Ba Mirror 2K 4K 8K Hairline Polished Cold Rolled Inox Ss Stainless Steel Plate Sheet 4X8FT 5X10FT
>>
wardrobe
>>
Addressable Rgb Waterproof IP67 60leds/m led pixe strip ws2811 digital rgb lc8806 led strip light
>>
Thermal break aluminum alloy folding windows good insulation and sound insulation
>>
Clear Adhesive Packing Based OPP Cheap Manufacture Low Noise Box Tape
>>
Powder Auger Filler 5kg Spicy Seasoning Condiment Filling Machine
>>
Expanded Metal Mesh Aluminum Suspended Ceiling Panels
>>
Multifunction Smoothie Juice Food Processor with Lownoise Cover Vacuum Commercial Blender
