| Negotiable | 1 Piece (MOQ) |
| Product Parameter | ||
| Model | GD_P48w | |
| Product | Industrial grade DIN Power Supply | |
Output | Voltage | DC 9-15V |
| Rated Current | 4A | |
| Current Range | 0.1-4A | |
| Ripple | <100mVP-P | |
| Output Accuracy | ±1.1% | |
| Voltage Regulation | ±1% | |
| Load Regulation | ±1% | |
| Power Rating | 48W peak output:50W | |
| Output Adjustment Range | ADJ | |
| Setup-Rise-Hold Time | 500ms 30ms/220VAC | |
Input | Voltage | 100~240VAC |
| Current | <0.6a(average current:0.1-0.6A) | |
| Currency Range | 47~63Hz | |
| Efficiency | 87%-89% | |
| Inrush Starting Current | Cold start 0.7A/110VAC | |
| Leakage Current | <5mA/230VAC | |
Protection Features | Over-power Protection | >50W, Grid protection, direct fault elimination |
| Over-voltage Protection | Input:>265V | |
| DC Short Protection | Interval hiccup on the power supply; and power supply recovers after short circuit removed | |
| Over-temperature Protection | Auto over-temperature protection,auto recovery when temperature drop to a safe range | |
Operation Environment | Operation Temperature/Humidity | -35ºC~+75ºC; 10%~95 %RH |
| Operation Temperature/Humidity | -45ºC~+90ºC; 10%~95 %RH | |
| Seismic resistance | 10~500Hz, 2G 10min/ 1 cycle, duration of 60 minutes, for each axis | |
Security &EMC Standard | Pressure resistance | Input output room: 3KVAC Input to ground: 1.5KVAC Output to ground: 0.5KVAC |
| Insulation resistance | Input output, input to ground, output to ground: 100M Ohms/500VDC | |
| safety standards | CE FCC | |
| Product /Packing Size(L*W*H) | 98*83*36mm 105*105*40mm | |
| N.W/G.W(kg) | 0.29/0.32Kg | |
Notes | 1.All the parameters are tested under the condition of 220V AC input, rated load, temperature at 25ºC and humidity at 70%. 2.Accuracy: setting errors, voltage regulation and load regulation. 3.Ripple test:Connect the power and the load device with 30cm twisted cable, and parallelly connect capacitor of 0.1uf and 47F on the load end, at last,get the result on 20M oscilloscope that connected to the load end. 4.Voltage Regulation: get the result under the condition that at rated load, input voltage from low to high. 5.Load Regulation:get the result from the load changes of 0%~100% on the tested output end. | |
