首页>叉车出租新闻>叉车出租新闻

天燃气叉车的使用特点介绍

2021-03-031112次
1.首先熟悉液化气叉车的相关手册,对液化气转换系统有一个全面的认识与了解,在叉车的使用过程中,不可将叉车停在接近热源或火源的地方,如明火、燃烧的烟蒂、火星、电焊、能产生高温的机器及电气设备旁;不可擅自动手调整或修改液化气转换装置;应按期实施定期保养及检查;保持警觉,发现任何泄漏或异常现象应立即处理。
1. be familiar with the relevant manual of lpg forklift truck, and have a comprehensive understanding of lpg conversion system. during the use of forklift truck, forklift truck should not be parked near the source of heat or fire, such as open fire, burning cigarette butt, mars, welding, high temperature machine and electrical equipment; not unauthorized. regular maintenance and inspection shall be carried out on schedule. keep alert and deal with any leakage or abnormal phenomena immediately.
2.做到合理的启动:双燃料如使用液化气气体,工作前应确认钢瓶上手动阀门是否已完全打开,叉车在常期闲置不用时,应将其手动阀门关闭;启动时不必踩油门,双燃料系统必须将切换开关旋置液化气位置,启动后,尤其天寒地带,好是暖车两三分种,让内燃机之冷却水系统升温后再行驶,以确保温水可流入汽化器,以加速汽化。
2. reasonable start-up: if using lpg for dual fuel, check whether the manual valve on cylinder is fully opened before work, and close the manual valve when forklift truck is idle for a long time; do not step on the accelerator when starting, the dual fuel system must switch the switch to rotate the lpg position, especially after starting, especially days in cold regions, it is better to warm the car two or three times, let the cooling water system of the internal combustion engine warm up and then run, to ensure that warm water can flow into the carburetor to speed up the vaporization.、
3.注意燃油切换方法(单燃料叉车不需考虑):对双燃料叉车而言,切换时应在叉车停稳时,且不可在行驶中切换;在汽油转换至液化气时,让内燃机继续以怠速运转,此时可将切换开关旋至中位,让化油器内积存汽油烧完为止,直至熄火,再将燃油切换开关旋至液化气位置,重新启动;由液化气转换到汽油时,可直接将切换开关旋至汽油位置不必停在中位,此时注意拔出拉索,双燃料系统在主要以烧液化气为主时,需让汽油箱内保持至少1/4的油量以备不时之需。且偶尔地需烧汽油,以确保汽油系统不因闲置过久而出现故障,防止输油管脆化,建议每个月烧10公斤汽油为好。
3. pay attention to the fuel switching method (single fuel forklift does not need to be considered): for dual-fuel forklift, when the forklift stops stable, and can not be switched in motion; when gasoline is converted to liquefied petroleum, let the internal combustion engine continue to run at idle speed, at this time the switch can be turned to the middle, so that the carburetor storage of gasoline burnout behavior. when converting from lpg to gasoline, the switch can be switched directly to the position of gasoline without stopping in the middle. at this time, the cable should be pulled out. the dual fuel system should keep at least 1/4 of the fuel in the gasoline tank when mainly burning lpg. quantity for emergency needs. and occasionally need to burn gasoline to ensure that the gasoline system is not idle for too long and failures to prevent the brittleness of the pipeline, it is recommended to burn 10 kilograms of gasoline per month as well.
4.做到正确地加气:加气有两种方式,一为换瓶;二为在叉车上直接充气。加气或换瓶时必须在室外,保证通风良好,安全应符合当地的消防标准的规定要求。叉车必须停稳、熄火,驾驶员离开驾驶座。四周严禁烟火、热源、火源。小心地处理钢瓶,不得碰撞、摔掷、或在地面上滚动。加气人员在加气的过程中必须全程监视,不得离开现场。充气时,将加气枪套在瓶上的填充阀上,并旋紧,同时将瓶上的80%的液位孔旋开,开始加气。当80%液位孔有白雾冒出时,应立即停止加气,将80%液位孔旋紧关闭,并检查液面计指示量是否正确。
4., correct aeration: there are two ways to add gas, one is to change bottles, the other is to directly inflate on forklifts. when filling or changing bottles, they must be outdoors to ensure good ventilation and safety should meet the requirements of local fire protection standards. the forklift must be stalled and extinguished. the driver will leave the driver's seat. fireworks, heat sources and fire sources are strictly prohibited. handle cylinders carefully, do not collide, throw or roll on the ground. the gas filling personnel must be monitored throughout the gas filling process and must not leave the scene. when inflating, the air gun sleeve is placed on the filling valve of the bottle and rotated tightly. at the same time, the 80% liquid level hole on the bottle is rotated open, and the gas is started. when 80% liquid level hole has white fog, should immediately stop aeration, 80% liquid level hole closed tightly, and check the level indicator is correct.
电动叉车与液化气叉车区别
difference between electric forklift truck and liquefied petroleum gas fork lift truck
液化气发动机属于内燃机,是燃烧燃料后通过推动气缸内活塞